Instruction Videos
How to Refill the ASUVI 2.0 case
Quick Guide
Text Instructions
This refill system works best when assembled gently and deliberately. Take your time, follow the steps below, and avoid forcing any part into place.
How To Load Your Refill
1. Remove the cap, then squeeze the two side buttons to release the neck.
2. Wind the base down (clockwise, viewed from the top) until you feel resistance. This can take quite a few turns, so keep going.
3. Rest your refill inside the body. Now slide the neck over the refill and press it back into the body until you hear a click.
4. If the stick is sitting above the rim of the neck, press it down firmly with your thumb to seat it flush.
How to Apply
- - Wind the stick up no more than 8 to 10 turns (about 1 cm above the rim).
- - After each use, wind the stick back down so it doesn't stick to the cap.
How to Refill the ASUVI 1.O case
1. Clean your reusable tube and the plastic disc inside. Once clean, wind the plastic disc back to the bottom of the tube (anti-clockwise).
2. Remove the cap of your refill and tip it upside down onto the rim of your reusable tube. The refill rim is slightly larger so that it fits over the tubes rim.
3. Press the base of the refill downwards as far as you can to push the stick into your reusable tube.
4. Pull the Bio-refill tube up and off and dispose appropriately.
How To Refill ASUVI Hand Wash
1. Fill 1/3 (80ml) of your bottle with tap water.
2. Tear/cut off the corner of your sachet. The smaller the hole the better (thinner stream of paste = disolves quicker).
3. Squeeze the concentrate paste into your bottle.
4. Fill the rest of the bottle with Boiling Water.
5. Replace the pump and shake for 15s.
6. Wait 10 mins for ingredients to disolve.